THE CORPORATION OF THE TOWNSHIP OF WEST LINCOLN
COMMITTEE OF ADJUSTMENT
AGENDA

-
Township Administration Building
318 Canborough Street, Smithville, Ontario

1.

 

The Chair will call to Order the evening's proceedings.

There are no requests at this time.  

Parcels: PIN No. 46050-001, PIN. No. 46050-0016, and PIN. No. 46050-0275


This proposal includes three applications, two boundary adjustments referring to Survey Sketch 15-16-105-06 and a lot creation severance referring to Survey Sketch 15-16-105-07.


The first boundary adjustment is proposing Part 3 (2.37ha) on Survey Sketch 15-16-105-06 to be severed and added to Part 2 (1.17ha) through this application and would be consolidated into a larger parcel for future restricted employment uses as outlined in the Spring Creek Secondary Plan (SCHSP). 


Additionally, the second boundary adjustment is proposing Part 1 (2.26 ha) on Survey Sketch 15-16-105-06 to be severed and added to Part 4 (4.96ha) through this application and would be consolidated into one larger parcel to implement the SCHSP for residential and employment uses.


Lastly, the lot creation severance application is proposing Part 1 (4.73ha) on Survey Sketch 15-16-105-07 to be severed from the subject property and retained for future employment uses. According to the SCHSP, the retained lands are intended to remain as institutional and the severed lands as restricted employment. The balance of PIN. No. 46050-0275 results in a lot creation as the lands are not merging with the abutting parcels.


If granted, together these applications would realign this area with the intended SCHSP to facilitate future residential, employment, and institutional uses. 

Property Address: 953 Boyle Road. 


This application is seeking relief from Table 1-2 Regulations for Accessory Buildings and Structures in Non-Agricultural Zones (found in Part 3) of the Township’s Zoning By-law 2017-70, as amended, to construct a detached accessory building with a total area of 185 square metres and located in the rear yard of the property.


A variance is requested for an increased ground floor area of a building no greater than 185 square metres, whereas, 120 square metres is the maximum ground floor area permitted for an accessory building in a Residential Low Density ‘R1A’ zone. Therefore, the requested relief is for 65 square metres. 


A variance is requested for an increased accessory lot coverage. The subject property currently has a detached private garage (82 square metres) and a chicken coop (8.5 square metres), and with the proposed accessory building, the total accessory lot coverage would be 275.5 square metres. Table 1-2 identifies 200 square metres as the maximum lot coverage for accessory buildings or structures within a residential zone. Therefore, the requested relief is for 75.5 square metres.


In addition, upon further review of the elevation drawings provided after the release of the notice, Staff identified a variance to allow a maximum accessory building height of 6 metres, measured from grade to the midway point between the eaves and the roof and ridge, whereas 5 metres is the maximum permitted.

There are no minutes for approval at this time.